24 0 6MB
Presented by: Paul YATOUTE Maguiman
03.11.2016
Coil fabrication
The copper The copper is 1.5 mm2
Process of puting out gain
Fabrication of coil We turn the coil on Anti-COIL WAY 144 and 81 turn inner and outer coil
Connexion according to the diagram of KF
Nano coated on fire I
Mix 3 GANS: CH3,CO2 and CUO
We mix 3 GANS togheter and put the coil we nano coated with fire inside.
Dry the coil after puting in the Gans
We dry the Coil after the processing in the GANS
Hydrogen on coil 1) Put soda costica in the hot water, 2) Put aluminium mesh on the bottom(the one we use is green) 3) Put alluminim on the water of soda costica 4) Put the dry coil with gans on it and cover it for 24h
Remark
We remark that when we put the aluminium in the soda costica,put coil and cover,we remark that in 24 H,the mixing turn in black color and the is one gans black in the down of the bottom
Dry the coil after hydrogen process
We dry again the coil after hydrogen process
GANS PROCESS 1) We use Sheet metal connected to the nanocoated copper coil 2) We put soda costica in the hot water 3) And put it in the boxe where we connected sheet metal with the coil at the distance of 12 cm 4) We get blue gans NB:By inspiration, i use it to spray the coil. I didn’t wash this gans because there is no compact gans at the down of bottom Only the color change in the blue.
Blue gans use to spray the coil
The coil Ready for conexion
Differente materials
Differente materials
Capacitor fabrication
1) We take aluminium paper 2) We the toilet paper and put on the aluminium paper 3) We spray the mixing of 3 gans(CH3,CO2 and CUO) on the paper wich is on aluminium 4) We dry it NB:I constate there is some things like seed on the the drying process. You can observe it ton the next picture.
Capacitor fabrication
Capacitor fabrication We roll the copper nanocaoted with the aluminim Paper where we have the drying gans on the paper. We turn it on anticlock way until it become hard.
Capacitor coil 45 turns
Capacitor fabrication
We roll the coil on aluminium
Capacitor conexion
We connected (-) together and (+) of capacitor toghether and the (-) of capacitor to the (-) of the stacker and the (+) goes to the (+) of stacker.I use 3 capacitors for one magrav .
Remark
We notice that, there is small salt inside because we use one gans water of CO2 to mixe in the 3 gans mixing where i make with salt
The boxes
The twins magrav wich give 95%
We plug the first magrav extention like you see on the picture
The twins magrav wich give 95% reduction
We plug the rest with the energy source and use the extention for the connection with the house
The twins magrav with 9 capacitors for 96.5% reduction
Same circuit of conexion with but we incresae the capacitors: 9 capacitor for one magrav so 18 capacitor for the twins magravs.
The twins magrav with 9 capacitors for 96.5% reduction
THANKS