MR 338 Clio Symbol 5 [PDF]

Zitiervorschau

Mechanisms and Accessories WINDOWS EXTERIOR PROTECTION

LB0P - LB03 77 11 203 518

SEPTEMBER 1999

"The repair methods given by the manufacturer in this document are based on the technical specifications current when it was prepared.

EDITION ANGLAISE

All copyrights reserved by Renault.

The methods may be modified as a result of changes introduced by the manufacturer in the production of the various component units and accessories from which his vehicles are constructed."

Copying or translating, in part or in full, of this document or use of the service part reference numbering system is forbidden without the prior written authority of Renault.

© RENAULT 1999

Mechanisms and Accessories Contents Pages

54 WINDOWS B Rear screen

54-1

55 EXTERIOR PROTECTION A Front bumper B Rear bumper

55-1 55-3

WINDOWS 154 Rear screen

54

A B

REMOVAL - REFITTING 16737R

Remove the lower adjustment shims (C) by unclipping them from the inside of the boot.

16736R

Unclip the cover from the third brake light by pressing the side retaining lugs (A) and slide it towards the front of the vehicle. Remove the mounting from the third brake light.

16738S

Disconnect the heated rear screen harness (B).

Fix two pieces of masking tape to the outside of the windscreen to protect the paintwork during the cutting operation. Pass the wire into the upper corner of the window using the cable threader needle. Fit the piercing tool and the pulling handle. Normal cutting to the wire.

54-1

WINDOWS Rear screen PREPARATION AND CLEANING

54

A B

NOTE: when applying the first sheet (E), we recommend that you mask zone F before application.

Refer to the technical note N° 371A on the general method for windscreen fitting preparation and adhesion.

Any overflow into the zone will be visible when the windscreen has been fitted. 1 2 3 4

Roof Windscreen Head lining Strip

STICKING AND FITTING THE WINDSCREEN

16739R

Fit the upper adhesive stops (D) and the lower adjustment shims (C). X = 110 mm NOTE: when removing-refitting, the lower adjustment shims (C) should be replaced systematically. 90794S

Set the windscreen in the aperture. Please adhere to the clearance and ensure that fitting is flush around the whole peripheral area.

16740R

54-2

155

EXTERIOR PROTECTION Front bumper

55

A

REMOVAL - REFITTING

16742R

– the ribbed clips (B) of the mudguard, – the two mounting bolts (C),

16741R

Remove: – the two upper mounting screws (A),

55-1

EXTERIOR PROTECTION Front bumper

55

A

16745R

16743R

Slide the bumper towards the front of the vehicle (1), to loosen it from the side centring fittings.

Remove: – the two side mounting bolts (D),

Lift the bumper at the level of the upper mountings (2). Remove the bumper while keeping the sides away (3).

16744R

– the lower mounting bolts (E).

55-2

155

EXTERIOR PROTECTION Rear bumper

55

A B

REMOVAL - REFITTING

16747R

– the lower mounting bolts (B). 16746R

Remove: – the two upper mounting clamps (A),

55-3

EXTERIOR PROTECTION Rear bumper

16748R

55

A B

16750S

– the number plate light using a flat screwdriver.

Remove: – the three mounting bolts (C) of the mudguard, – the mounting bolt (D),

Disconnect the wiring harness.

16751R

16749R

Remove the side mounting bolts (F).

– the skirt lower mounting bolts (E).

Slide the bumper towards the rear to loosen it from the side centring fittings. For safety reasons, we recommend that two people carry out this operation.

55-4