Documents - Tips - Solidwize CSWP Sample Exam 1 Segment 2 [PDF]

Zitiervorschau

SolidWize Online SolidWorks Training CSWP Sample Exam 1 (2012) Segment 2 of the CSWP Core -This test is made up of a series of problems broken down into sets of questions. Each problem set of questions comes with a description that outlines the problems to be solved for that set. -This section contains 9 questions -You should be able to complete all 9 questions within 40 minutes -Consult answer key after completion of this section

Segment 2A- Configurations Question 1-Existing Configurations Unit System: MMGS (millimeter, gram, second) Decimal Places: 2 -Open Wize2A_Start.sldprt (in the segment 2 folder) How many existing configurations are there in the part? a. 2 b. 3 c. 4 d. 5

Question 2- Active Configuration Unit System: MMGS (millimeter, gram, second) Decimal Places: 2 -Activate configuration “C” What is the mass of the part (grams)?

______________

Question 3- New Configuration “Z” Unit System: MMGS (millimeter, gram, second) Decimal Places: 2 -Create a new configuration based on configuration “B” -Create a through hole as indicated in the image below that will be suppressed in all other configurations except for “D” and “Z”. (This feature will only be unsuppressed in configurations “D” and “Z”) Note: This hole is coincident to the origin of the part What is the mass of the configuration “Z” (grams)? a. b. c. d.

972.63 550.64 1438.90 1543.22

Question 4- Switch Configuration Unit System: MMGS (millimeter, gram, second) Decimal Places: 2 -Activate Configuration “D” What is the mass of the configuration “D” (grams)?

_____________

Question 5- Design Table Unit System: MMGS (millimeter, gram, second) Decimal Places: 2 Material: Copper Density: 8900 kg/m^3 -Create a design table using the “Auto-Create” options. -Create a new configuration “E” by copying the row for configuration “A” and pasting a new row. -Within the design table, assign the following dimensions to configuration “E”: D1@sketch7=5 D2@sketch7=6 D3@sketch8=65 D4@sketch8=33 BoreDiameter@sketch5=28 What is the mass of the configuration “E” (grams) ____________

Segment 2B- Part Modifications Question 6 – Change Feature Depth Unit System: MMGS (millimeter, gram, second) Decimal Places: 2 -Open Wize2B_Shell_Start.sldprt (in the segment 2 folder) -Make the proper change to the part as indicated below. (change from 1 to 2)

What is the mass of the modified part?

________

Question 7 – Change Shell Thickness Unit System: MMGS (millimeter, gram, second) Decimal Places: 2 -Make the proper change to the part as indicated below. (change from 1 to 2)

-Only the shell thickness changes What is the mass of the modified part?

____________

Question 8 – Feature History Unit System: MMGS (millimeter, gram, second) Decimal Places: 2 -Make the proper change to the part as indicated below. (change from 1 to 2)

-Change shell thickness and part dimensions as shown What is the mass of the modified part?

_________________

Question 9 – More Changes/Lack of Creative Title Unit System: MMGS (millimeter, gram, second) Decimal Places: 2 -Make the proper change to the part as indicated below. (change from 1 to 2) Hint: the initial sketch needs to be modified (II) indicates Parallel

What is the mass of the modified part? __________