31 0 2MB
Ericsson In-House Team
Contents Adjust laptop &Log in to Moshell. Configure RET on Baseband5216. lock & unlock RET on Baseband5216.
Force calibration for Ret on Baseband5216.
Adjust laptop &Log in to Moshell. • • • •
› › › ›
Connect Ethernet cable between LMT port in BB5216 and PC LAN cable Set PC IP setting as below IP: 169.254.2.3 Subnetmask: 255.255.0.0
• After log in to moshell. Need to put in “Username/Password” after “lt all” Maintenance User Id/Password: “rbs/rbs”
Configure RET on Baseband5216. Write command st ret to show ret operation state(enabled-disabled) as below P.S .
If the op.state is disabled check if ret is configured or not by command get . Uniqueid
To configure it write the following command St AntennaUnitGroup=1,AntennaNearUnit=1 UniqueId XXXX then press enter then y(yes) Note xxxx is serial number on ret unit for example
lock & unlock RET on Baseband5216. To determine if ret is locked or not write the following command st ru as If admin state is locked write this command to unlock it as below p.s ,if you want lock it use bl instead of deb.
Force calibration for Ret on Baseband5216 To show ret op state write command st ret . If op state is disabled we need to force calibration for ret unit. Note that each ret unit has private proxy number as in below. To force calibration for ret write acl xx which xx is proxy number for ret unit , then write acc xx forcecalibration then press enter then yes as in below p.s .
To ensure that force calibration is finished write command get xx as below p.s
Finally check ret op state by command st ret to ensure that all ret unit is enabled as below p.s