30 0 92KB
Ericsson Internal DESCRIPTION Prepared (also subject responsible if other)
1( 9 )
No.
/ XSNGLIN
23/1551-LZA 701 0001 Uen
Approved
Checked
EAB/ FJG/YP ( Louise Cederlund)
Date
Rev
2007-11-27
D
Reference
PSU-DC-31 and PSU-AC-31 Unit Description Copyright © Copyright Ericsson AB 2006 2007. All rights reserved.
Disclaimer No part of this document may be reproduced in any form without the written permission of the copyright owner. The contents of this document are subject to revision without notice due to continued progress in methodology, design and manufacturing. Ericsson shall have no liability for any error or damage of any kind resulting from the use of this document. Contents
A4 XSEIF R5
Page
1 1.1 1.2 1.3 1.4 1.5 1.6
PSU-DC-31 Unit Description .. .. ... .. ... ... .. ... ... .. ... .. ... ... .. ... .. ... ... .. Product Overview ... .. ... .. ... ... .. ... .. ... ... .. ... ... .. ... .. ... ... .. ... .. ... ... .. Dimensions .. .. ... ... .. ... .. ... ... .. ... .. ... ... .. ... ... .. ... .. ... ... .. ... .. ... ... .. Power Consumption and Heat Generation . .. ... ... .. ... .. ... ... .. ... .. ... ... .. Function Description .. ... .. ... ... .. ... .. ... ... .. ... ... .. ... .. ... ... .. ... .. ... ... .. Interfaces . ... .. ... ... .. ... .. ... ... .. ... .. ... ... .. ... ... .. ... .. ... ... .. ... .. ... ... .. Revision Information .. ... .. ... ... .. ... .. ... ... .. ... ... .. ... .. ... ... .. ... .. ... ... ..
2 2 3 3 3 4 5
2 2.1 2.2 2.3 2.4 2.5
PSU-AC-31 Unit Description .. .. ... .. ... ... .. ... ... .. ... .. ... ... .. ... .. ... ... .. Product Overview ... .. ... .. ... ... .. ... .. ... ... .. ... ... .. ... .. ... ... .. ... .. ... ... .. Dimensions .. .. ... ... .. ... .. ... ... .. ... .. ... ... .. ... ... .. ... .. ... ... .. ... .. ... ... .. Power Consumption and Heat Generation . .. ... ... .. ... .. ... ... .. ... .. ... ... .. Function Description .. ... .. ... ... .. ... .. ... ... .. ... ... .. ... .. ... ... .. ... .. ... ... .. Interfaces . ... .. ... ... .. ... .. ... ... .. ... .. ... ... .. ... ... .. ... .. ... ... .. ... .. ... ... ..
5 6 6 7 7 8
Ericsson Internal DESCRIPTION Prepared (also subject responsible if other)
2( 9 )
No.
/ XSNGLIN
23/1551-LZA 701 0001 Uen
Approved
Checked
EAB/ FJG/YP ( Louise Cederlund)
1
Date
Rev
2007-11-27
D
Reference
PSU-DC-31 Unit Description The PSU-DC-31 is a variant of the Power Supply Unit (PSU) that converts DC to DC (PSU-DC).
PSU DC
Output +27.2 VDC 1500 W
Fault Operational Observation
Alarm/ Control
Input -48/-60 VDC 45 A
P015622B
Figure 1
1.1
PSU-DC-31
Product Overview The PSU-DC converts incoming DC power ranging from 40 V DC to 72 V DC to the regulated DC voltage of +27.2 V DC. The maximum output power is 1,500 W.
1.1.1
Main Functions The PSU DC: •
Supplies the correct DC voltage to the RBS
•
Sends alarms to the Distribution Switch Unit (DXU)
Ericsson Internal DESCRIPTION Prepared (also subject responsible if other)
3( 9 )
No.
/ XSNGLIN
23/1551-LZA 701 0001 Uen
Approved
Checked
EAB/ FJG/YP ( Louise Cederlund)
•
1.2
Date
Rev
2007-11-27
D
Reference
Indicates local alarms
Dimensions The table below shows the physical characteristics of the PSU-DC. Table 1
1.3
PSU-DC Size and Weight
Height
Width
Depth
Weight
267 mm
61 mm
226 mm
4.5 kg
(6HE × 44.45 mm)
(12TE × 5.08 mm)
Power Consumption and Heat Generation The table below shows the power consumption and heat generation. Table 2
1.4
Power Consumption and Heat Generation
Maximum Power Consumption
Maximum Heat Generation
1,724 W
224 W
Function Description The PSU-DC consists of the following main units:
1.4.1
•
Input filter, Electromagnetic Compatibility (EMC) filter
•
DC-to-DC converter
•
Output filter, EMC filter
•
Control and supervision circuits
Input Filter The incoming voltage first passes through the input filter (EMC filter), where it is filtered to prevent unwanted signals from being radiated from the PSU-DC.
1.4.2
DC/DC Converter The DC/DC converter is a switch mode converter that converts the DC voltage into a square wave. This is then fed into the primary side of the transformer. The converter limits the current in overload situations. In the transformer, the voltage is converted to a 24 V AC square wave. This wave is rectified to DC voltage through a diode rectifier.
Ericsson Internal DESCRIPTION Prepared (also subject responsible if other)
4( 9 )
No.
/ XSNGLIN
23/1551-LZA 701 0001 Uen
Approved
Checked
EAB/ FJG/YP ( Louise Cederlund)
Date
Rev
2007-11-27
D
Reference
The output provides constant power regulation, rather than the more common current limited regulation, and delivers 1,500 W over the output voltage.
1.4.3
Output Filter The output filter (EMC filter) filters the output voltage to prevent the radiation of unwanted signals from the PSU-DC.
1.5
Interfaces
1.5.1
Signal and Power Interfaces Input Data The table below shows the input data for the PSU-DC. Table 3
Input Data
Characteristic
Value or Quantity
Nominal input voltage
48 or
60 V DC
Input voltage range
40 to
72 V DC
Non-destructive voltage
0 to
80 V DC
Output Data The table below shows the output data for the PSU-DC. Table 4
Output Data
Characteristic
Value or Quantity
Default output voltage
+27.2 V DC
Output power
1,500 W
Connectors Table 5
Connectors
Function
Connector Type
Power output
2-Pole DC power connector
Alarm/control bus
RJ-45
Power input
2-Pole DC power connector
Ericsson Internal DESCRIPTION Prepared (also subject responsible if other)
5( 9 )
No.
/ XSNGLIN
23/1551-LZA 701 0001 Uen
Approved
Checked
EAB/ FJG/YP ( Louise Cederlund)
1.5.2
Date
Rev
2007-11-27
D
Reference
Operator Interface Indicators The table below shows the indicators for the PSU-DC. Table 6
1.6
PSU-DC Indicators
Indicator
Color
Fault
Red
Operational
Green
Observation
Yellow
Revision Information Other than editorial changes, this document has been revised as follows:
2
•
Updated figure ’PSU-DC-31’ due to changes in the label for the input connector.
•
Updated the input voltage data in section ’PSU-DC-31 Unit Description’.
PSU-AC-31 Unit Description The PSU-AC-31 is a variant of the Power Supply Unit (PSU) that converts AC to DC (PSU-AC).
Ericsson Internal DESCRIPTION Prepared (also subject responsible if other)
6( 9 )
No.
/ XSNGLIN
23/1551-LZA 701 0001 Uen
Approved
Checked
EAB/ FJG/YP ( Louise Cederlund)
Date
Rev
2007-11-27
D
Reference
PSU AC
Output +27.2 VDC 1520 W
Fault Operational Observation
A1
A2 Alarm/load sharing
Input 45-65Hz 200-250Vac
P015962A
Figure 2
2.1
PSU-AC-31
Product Overview The PSU-AC converts incoming AC power ranging from 200 to 250 V AC to the regulated DC voltage of +24 V DC. The maximum output power is 1,520 W.
2.1.1
Main Functions The PSU-AC:
2.2
•
Communicates with the DXU.
•
Adjusts voltage
•
Performs sharing between parallel units
•
Indicates local alarms
Dimensions The table below shows the physical characteristics of the PSU AC.
Ericsson Internal DESCRIPTION Prepared (also subject responsible if other)
7( 9 )
No.
/ XSNGLIN
23/1551-LZA 701 0001 Uen
Approved
Checked
EAB/ FJG/YP ( Louise Cederlund)
Table 7
2.3
Date
Rev
2007-11-27
D
Reference
PSU-AC Size and Weight
Height
Width
Depth
Weight
267 mm
61 mm
226 mm
4.5 kg
(6HE × 44.45 mm)
(12TE × 5.08 mm)
Power Consumption and Heat Generation The table below shows the power consumption and heat generation. Table 8
2.4
Power Consumption and Heat Generation
Maximum Power Consumption
Maximum Heat Generation
1,700 W
183 W
Function Description The PSU-AC consists of the following main units:
2.4.1
•
Input filter, EMC filter
•
Bridge
•
Booster converter
•
AC/DC converter
•
Output filter, EMC filter
•
Control and supervision circuits
Input Filter The incoming sine voltage first passes through an internal fuse and then the input filter (EMC filter), where it is filtered to prevent unwanted signals from being radiated from the PSU-AC.
2.4.2
Bridge The bridge rectifies the incoming AC.
2.4.3
Boost Converter The boost converter draws a sinusoidal input current in phase with the input voltage, enabling the power supply to have a high power factor and low distribution on input current. The output from the boost converter is +400 V AC.
Ericsson Internal DESCRIPTION Prepared (also subject responsible if other)
8( 9 )
No.
/ XSNGLIN
23/1551-LZA 701 0001 Uen
Approved
Checked
EAB/ FJG/YP ( Louise Cederlund)
2.4.4
Date
Rev
2007-11-27
D
Reference
AC/DC Converter The AC/DC converter is a phase-shifted, soft-switched, full-bridge converter that converts the incoming 400 V AC to +24 V DC output voltage. The output provides constant power regulation, rather than the more common current–limited regulation, and delivers 1,520 W over the full input range.
2.4.5
Output Filter The output filter (EMC filter) filters the output voltage to prevent the radiation of unwanted signals from the PSU-AC.
2.5
Interfaces
2.5.1
Signal and Power Interfaces Input Data The table below shows the input data for the PSU-AC. Table 9
Input Data
Characteristic
Value or Quantity
Nominal input voltage
+200 to +250 V AC
Frequency
45–65 Hz
Non-destructive voltage
0 to+275 V AC
Output Data The table below shows the output data for the PSU-AC. Table 10
Output Data
Characteristic
Value or Quantity
Nominal output data
+24 V DC
Default output voltage
+27.2 V DC
Voltage range
+22.0 to +29.0 V DC
Output power
1,520 W
Ericsson Internal DESCRIPTION Prepared (also subject responsible if other)
9( 9 )
No.
/ XSNGLIN
23/1551-LZA 701 0001 Uen
Approved
Checked
EAB/ FJG/YP ( Louise Cederlund)
Date
Rev
2007-11-27
D
Reference
Connectors Table 11
2.5.2
Connectors
Function
Connector Type
Power output
2-Pole DC power connector
Alarm/control bus
RJ-45
Power input
3-Pole AC power connector
Operator Interface Indicators The table below shows the indicators for the PSU-AC. Table 12
PSU-AC Indicators
Indicator
Color
Fault
Red
Operational
Green
Observation
Yellow