Smacna Duct Fitting Loss Table [PDF]

DUCT DESIGN TABLES Table 14-10 LOSS COEFFICIENTS, ELBOWS (Cont.) Use the velocity pressure (Vp) of the upstream secti

48 6 102KB

Report DMCA / Copyright

DOWNLOAD PDF FILE

Papiere empfehlen

H Carb Fat Loss

3 1 6MB Read more

Erlang Table

3 1 23KB Read more

Prefix Table

0 0 99KB Read more

Table Trigonometrique

2 2 56KB Read more

Vibration Table

0 0 246KB Read more

Table Elevatrice - Corrigé

0 0 313KB Read more

Table Des Matieres

0 0 169KB Read more

This Is My Table

0 0 333KB Read more

Table 1: Freon 12 Saturation Properties - Temperature Table

0 0 60KB Read more

IE 202 PS 7 1.: Table 1 Table 2

0 0 295KB Read more

Smacna Duct Fitting Loss Table [PDF]

Author / Uploaded
Karthikeyan Sankarrajan

0 0 0
Gefällt Ihnen dieses papier und der download? Sie können Ihre eigene PDF-Datei in wenigen Minuten kostenlos online veröffentlichen! Anmelden

Datei wird geladen, bitte warten...

Zitiervorschau

DUCT

DESIGN

TABLES

Table 14-10 LOSS COEFFICIENTS, ELBOWS (Cont.) Use the velocity pressure (Vp) of the upstream section. Fitting loss (TP) = C x Vp D. Elbow, Rectangular, Mitered (15)

E. Elbow, Rectangular, Mitered with Converging or Diverging Flow (15)

F. Elbow, Rectangular, Smooth Radius without Vanes (15)

U.S. Units For Standard Air: Re = 8.56 DV

(Metric Units) (Re = 66.4 DV)

where: D = duct diameter, inches (mm) V = duct velocity, fpm (m/s) For Rectangular Ducts:

14.20

AND

CHARTS

CHAPTER 14

Table 14-10 LOSS COEFFICIENTS, ELBOWS (Cont.) Use the velocity pressure (Vp)of the upstream section. Fitting loss (TP) = C x Vp G. Elbow, Rectangular, Smooth Radius with Splitter Vanes (2)

NOTES FOR THIS FIGURE ONLY: A) See Page 5.14 to calculate splitter vane spacing. B) CR = Curve Ratio

C) Use correction factors in Note 1 on Page 14.19 for elbows other than 90°.

14.21