Foundation Drawing For Tanks 10M3 5M3 [PDF]

Zitiervorschau

2 Units -

Galvanized angle steel

The angle steel is not less than 1m away from the tank foundation, the distance between the two angle steels is not less than 5m, and it is flush with the ground

Base plan of tank

Cushion reinforcement

Cushion reinforcement

Embedded parts map

Embedded parts steel plate diagram

Steel plate

Round bar

Fine stone concrete leveling Steel cage

Ground

Concrete cushion C25 Cushion reinforcement Concrete cushion C15

Detailed drawing of the base section of the storage tank ========= Ground wire

Soil or concrete cushion C15

Instruction: 1. When the storage tank is installed, the storage tank support bottom plate is welded to the foundation embedded parts; the C25 steel plate embedded parts are poured into a whole with the concrete and kept on the same level; 2. After the civil construction is grooved, the bottom should be tamped and the foundation should be placed on the solid soil layer; in addition to meeting the requirements of this figure, the depth of the foundation should exceed the maximum depth of the local frozen layer in cold areas; 3. The steel plate embedded parts shall be prepared by the user before the civil construction according to the specifications indicated in the figure; 4. The empty weight of the equipment is 8115kg, and the maximum weight of liquid oxygen, liquid argon and liquid nitrogen when fully loaded: 19137kg, 21632kg, 15904kg; 5. This drawing is for reference only, not as a formal construction drawing. The formal drawing should be completed by a qualified unit based on the actual survey data of the geological survey.

2 Units -

Galvanized angle steel

The angle steel is not less than 1m away from the tank foundation, the distance between the two angle steels is not less than 5m

Cryogenic Liquid Tank

CFLA-10/1.6 Foundation Drawing

CFLA-5/1.6